Revamp for three
The crusher shell and the eccentrically gyrating mantle continu - ously changes. the feed material that is fed into the crushing chamber from above is progressively crushed between the crushing elements c, finally exiting the crushing chamber at the bottom f under the influence of gravity.Mar 19, 2020 the kubria crusher design has a hydraulically supported main shaft and fixed upper crusher chamber. crushing takes place between the concaves in the crushing chamber and the mantle-lined crushing cone figure 1, which is rotated by an eccentric drive in the lower section.Crusher operation • relation between css and shape – the size where the best shape can be found is at css – it is very difficult for cubical stones larger then css to pass the chamber – breakage of stones creates flaky particles. smaller flaky stones will more easily find its way through the chamber Inside your cone crusher. the basic principle is straightforward the material to be crushed the feed, drops into the crushing chamber. the mantle is a moving part that gyrates in an eccentric motion. that is, it doesn’t remain completely centred – it swings slightly as it rotates, continually altering the gap between the mantle and the Apr 03, 2015 a cone crusher is suitable for crushing a variety of mid-hard and above mid-hard materials. feed is dropped to the crusher from the top and it is crushed between the crushing chamber and the slowly rotating cone. cone crushers are mostly used for the large scale crushing May 01, 2021 to optimize the crushing chamber of the gyratory crusher, the discrete element method dem is used to explore the influence of the concave curve height, concave curve radius, eccentric angle, and mantle shaft speed on the performance of the crushing chamber in this paper, here, the dem analysis model of iron ore particle is established based on the bonded particle model.